Baby Trend Deluxe Trend Nursery Center 8136BCC - Manual (Page 7)

NOTE: Playard MUST be in a locked set-up position before
installing and using the bassinet feature.
CONTENTS (Fig. 1):
2 Right corner supports
2 Left corner supports
1 Nylon bassinet insert
2 Long metal tubes
2 Medium metal tubes
2 Short metal tubes
ASSEMBLY
1. Insert 1 short tube into a medium tube lining up the snap button and
the hole opening. Make sure the snap buttons are exactly fitted into
the holes (Fig. 2). Repeat for the second set of tubes.
2. Unroll the nylon bassinet fabric. Insert one set of the connected
tubes into each long side of the bassinet sleeve (Fig. 3).
NOTE: The printed warning label should be facing toward the
inside of the bassinet and is readable.
3. Insert 1 long tube into the short side of the bassinet sleeve. Repeat
for remaining side.
4. Slide the corner supports onto the ends of each tube (Fig. 4). The
corner support with a hole is used for the mobile. Place this corner
support on the end opposite the changing table.
The bassinet canopy is secured to the bassinet with snaps on the
outside sleeve. Snap both on the ends of the canopy to the sleeve as
shown in (Fig. 4a). The rear section of the canopy is connected to
the bassinet sleeve as shown in (Fig. 4b).
5. Place assembled bassinet onto the Playard. Push down each of the
corner supports (Fig. 5).
NOTE: The corner supports are designed to rest on long side of
Playard (40 in. rail) and wrap around the short side of the Playard
top corner pieces.
6. Place the Playard mattress into the bassinet with the padded side
facing up (Fig. 6).
7
TO ASSEMBLE YOUR BASSINET
Figure 5.
Figure 1
Figure 2
Figure 3.
Figure 4.
Figure 6. Figure 4a. Figure 4b.
snap
bassinet