Black Box FX150A - Manual (Page 25)

26
LINESHARE PRO
You can reset the ring count for
the Ring Reduction feature to six
rings by performing any of the
following steps:
• Lift the receiver of the phone
device connected to the primary
default port.
• Answer a call from any phone
before the call is routed to
another port.
• Place an outbound call from a
phone connected to the primary
default port of the Lineshare
Pro.
(See Section 5.4 for more
information about the No Answer
Cascade and Ring Reduction
features.)
4.3 Answering Incoming Calls
Depending on your configuration,
you can answer incoming calls from
a phone device connected to the
primary default port. You can then
conduct the call normally, for as
long as you like.
4.4 Answering Calls from Port 1
If, after answering a call, you hear
silence on the line, the call is likely
coming from a fax or modem that
did not produce a routing tone.
Simply transfer the call to Port 2,
Port 3, or Port 4 by entering the
appropriate access code. (The
Inbound Tone Transfer Feature
must be turned on for this transfer
to function.)
• From a tone phone, enter 22 for
Port 2, 33 for Port 3, or 44 for
Port 4 (if you answer a call from
another port, you can press 11
for Port 1).
• From a pulse dialing phone, dial
3 for Port 2, 4 for Port 3, and 5
for Port 4.
If a caller verbally requests a
device connected to a port, you
can route the call by entering the
appropriate access code.
NOTE
The tone access codes used
in these examples are
factory-preset. They may be
changed according to your
needs. See Section 5.4 for
instructions.
4.5 Answering Calls with a TAD
If your TAD answers a call from
PORT 1, the caller can perform one
or both of the following tasks:
• record a voice message on the
TAD
• transfer their call to Port 2, Port
3, or Port 4
We recommend that you use your
TAD announcement message to
provide callers with instructions for
transferring their calls. Following is a
sample announcement message that
you may want to use: