Black Box FX150A - Manual (Page 46)

47
LINESHARE PRO
To select different protocol tones
for all ports, press the following on
your tone phone:
2 3 Protocol Tone Access Signal
0 Select all ports 1 through 4
The desired new protocol tones
* End programming sequence (3
beeps indicate correct entry)
(Optional entries for additional
changes)
* Save changes and exit
programming
NOTE
You must enter all four digits
to associate a tone to each
port. If you enter only one or
two numbers, the Lineshare
Pro will produce an error
tone.
Do not assign a single
protocol tone to more than
one port. If you inadvertently
assign a protocol tone to
more than one port, the
Lineshare Pro will produce
an error tone.
[3] Cascade Port Order
Cascade Port Order operates only
when the Lineshare Pro is
configured in the non-secured
mode.
This function sets the assigned
order for the No Answer Cascade
and Answer/Disconnect Cascade
features.
The sequence of the Cascade Port
Order can be set to default to any of
the Lineshare Pro ports. The
Cascade Port Order is factory-preset
to 1 2 3 4 *.
To change the Cascade Port Order
to reverse its default order
(4 3 2 1), enter the programming
mode and press the following on
your tone phone:
3 Cascade Port Order
4 3 2 1 The desired new cascade
order
* End programming sequence (3
beeps indicate correct entry)
(Optional entries for additional
changes)
* Save changes and exit
programming