Black Box FX150A - Manual (Page 47)

48
LINESHARE PRO
NOTE
You can enter one, two,
three, or all four port
numbers in this function.
The Lineshare Pro will
release a call after it reaches
the last port in this
sequence.
[4] Phantom Ring Style
When the Lineshare Pro answers a
call, it produces a “phantom” ring
signal. This tone is intended to make
the switching process transparent to
the caller. The Lineshare Pro has
seven (7) different phantom ring
types to choose from, allowing you
to select a ring style similar to your
local phone company’s ring signal.
The following ring types are
available:
1 U.S. style 1: 2-second ring, 4-
second silence, dual tones
2 Belgium style: 1-second ring,
3-second silence
3 European style: 0.4-second ring,
0.2-second silence
4 Special style: 1-second ring,
5-second silence
5 U.K. style: 1.5-second ring,
1.5-second silence
6 U.S. style 2: 2-second ring, 4-
second silence, single-frequency
low tone
7 U.S. style 3: 2-second ring, 4-
second silence, single-frequency
high tone
The factory-preset Phantom Ring
Style is U.S. style 1, 4 1 *.
To change the Phantom Ring
Style, enter the programming mode
and press the following on your tone
phone:
4 Phantom Ring Style
The desired ring style
* End programming sequence
(3 beeps indicate correct entry)
(Optional entries for additional
changes)
* Save changes and exit
programming
[5] Emergency Call Override
Emergency Call Override allows you
to interrupt a call that is in process
on either Port 2, Port 3, or Port 4.
The Emergency Call Override
feature is factory-preset OFF, 5 0 *,
and will not allow interruption of
calls. When ON, this feature has
two modes of operation as follows:
1 Automatic
2 Manual