Black Box ASTCKEY - Manual (Page 16)

Auto-Sync Time Clock
2-6 724-746-5500 | blackbox.com
NOTE: For units with the FPR option, disconnect the FPR battery pack cable
connector if the Auto-Sync Time Clock will not be plugged into AC power for
an extended amount of time. Leaving the battery pack connected without
charging for a long time could promote battery harm and damage to the
clock.
11. Carefully reinstall the top plate by first inserting
the rear tabs into the appropriate rear notches,
making sure the rear centering tab is in its notch.
Then push the plate forward (see right-hand
figure) while properly aligning the top plate sides
and front. Finally push the top plate downward to
lock it firmly into position with the front tabs (see
Figure 2-9).
Figure 2-9. Top Plate Installed.
12. Insert the Ethernet connector through the hole in the rear of the top plate into
the RJ-45 network connector (previously disconnected in Step 4).
13. Insert and tighten the two (2) side retaining screws (one on right and left front
sides) for the top plate (see Figure 2-9).
14. Replace the upper cover of the Auto-Sync Time Clock (see Figure 2-2).
15. Connect the clock Ethernet cable to a network connection and plug the AC
power transformer into a wall socket.