Black Box ASTCKEY - Manual (Page 22)

Auto-Sync Time Clock
2-12 724-746-5500 | blackbox.com
NOTE: Plugging the AC power cord into a wall socket will cause the printer carriage
to move up. When AC power is not connected properly or the PoE is not
functioning, the colon will not flash (see Error Messages in Chapter 6).
2.8. Wall Mounting
The following procedure is recommended for wall mounting:
1. With the cover removed, the wall mount plate can be
removed by using your index finger as shown to pry open the
bottom portion (see arrow 1). Slide the wall mount plate
down in the direction of arrow 2. Use caution not to disrupt
the power and Ethernet cables on the back when removing
the wall mount plate.
2. Knock out the three holes in the
mounting plate.
3. Mount the plate on the wall using three #10
screws or equivalent.
4. Align the Auto-Sync Time Clock with the hooks on the mounting plate. Press
down and toward the wall until a "CLICK" is heard. Replace the cover, lock it and
remove the key. Your Auto-Sync Time Clock is now wall mounted.
NOTE: Be sure to wall mount your Auto-Sync Time Clock within 6ft of an 110V
power source and an Ethernet connection (AC power is not required if
equipped with PoE option).
2.9. Printing
2.9.1. The First Printout
Please verify the following before attempting to print:
1. Is all the packaging material removed from inside the clock?
2. Is the FPR battery connected? (optional)
3. Is the cover securely on the clock?