Philips Lumea IPL Haarentfernungssystem User Manual

Page 16

Advertising
background image

Tanning with artificial light

- Follow the instructions in ‘Sun exposure before treatment’ and ‘Sun

exposure after treatment’ above.

Tanning with creams

- If you have used an artificial tanning lotion, wait until the artificial tan

has fully disappeared before you use Philips Lumea.

Note: For more details on unwanted skin reactions, see chapter ‘Using the

appliance’, section ‘Possible side effects and skin reactions’.

Using the appliance

Check the recommended light intensities table in chapter ‘Preparing for

use’, section ‘Setting the light intensity’ to determine which light intensities

are most suitable for your skin and body hair colour. Use the appliance in

a well-lit room; this reduces the perceived brightness of the flash. Shave

the area you intend to treat before you use the appliance (see chapter

‘Preparing for use’, section ‘Preparing treatment areas’).
If the treatment becomes intolerably painful at any point in time, reduce

the light intensity setting until the treatment is comfortable again. If you

notice skin reactions stronger than slight redness, stop the treatment

immediately and read section ‘Possible side effects and skin reactions’ in

this chapter.
First use and skin test

1

Attach the body attachment to the appliance.

The body attachment can be used to treat unwanted body hair on all

body areas below the neck (for exceptions, see chapter ‘Important’, section

‘Contraindications’).

2

Choose an area close to the area you intend to treat.

3

Press the on/off button to switch on the appliance.

, The appliance always starts automatically at the lowest setting.

4

Apply one flash at the lowest recommended intensity for your skin

type (for instructions on how to release a flash, see steps 6 to

9 of section ‘Subsequent use’ in this chapter).

5

As long as it feels comfortable (not painful), increase the setting by

one level within the recommended range for your skin type and

apply one flash for each setting. Do not apply more than one flash on

the same spot.

ENGLISH

16

Advertising