Philips Lumea IPL Haarentfernungssystem - Manual (Page 22)

After use
- Do not apply any perfumed cosmetics to the areas treated immediately
after treatment.
- Do not use deodorant immediately after treating the underarms. Wait
until any skin redness has disappeared completely.
- See chapter ‘Preparing for use’, section ‘Tanning advice’ for information
about sun exposure and artificial tanning.
Cleaning and maintenance
To ensure optimal results and a long life for the appliance, clean the appliance
before and after each use and, if necessary, also during the treatment. The
appliance loses its effectiveness if you do not clean it properly.
Never clean the appliance or any of its parts under the tap or in the
dishwasher.
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the appliance.
Never scratch the light exit window or the metallic frame inside
the attachments.
Note: Make sure that the contact switches of the safety ring do not get
congested with dirt.
Note: Stop using the appliance when it is no longer possible to clean the
light exit window or the attachment. For replacement, see chapter ‘Ordering
accessories’.
1 Switch off the appliance, unplug it and let it cool down.
Note: The light exit window becomes hot during use. Make sure it has cooled
down before you clean it.
2 To remove the attachment, put your fingers in the recesses at the
top and bottom and pull gently. The attachment should come off
easily.
3 Moisten the soft cloth supplied with the appliance with a few drops
of water and use it to clean the following parts:
- the light exit window
- the outside surface of the attachment
- the metallic frame inside the attachment
Note: If water does not clean effectively, use a few drops of high-percentage
alcohol to clean the parts mentioned above.
Note: A contaminated light exit window and/or attachment can look like this
picture. Make sure you clean the appliance before and after each use and,
if necessary, also during the treatment according to the instructions in this
section.
Tip: If it is no longer possible to clean the edges of the attachment with the
enclosed cleaning cloth, use a cotton bud instead. Make sure that no fluff
or fibres stay behind on the attachment or on the light exit window.
4 If necessary, clean the outside of the appliance with the dry soft
cleaning cloth supplied with the appliance.
ENGLISH
22