Briggs & Stratton Electric Pressure Washer - Manual (Page 14)

14 BRIGGSandSTRATTON.COM
5. Using a garden hose, remove additional debris by back
flushing water through nozzle extension. Back flush
between 30 to 60 seconds.
6. Reconnect nozzle extension to spray gun.
7. Reconnect water supply, turn on water, and move
master ON/OFF switch to ON.
8. Test pressure washer by operating with nozzle in every
available position.
Pump and Motor Maintenance
This pressure washer does not require any maintenance on
the pump or motor. Both assemblies are pre-lubricated and
sealed, requiring no additional lubrication ever.
Storage
Water should not remain in the unit for long periods of time.
Sediments or minerals can deposit on pump parts and
“freeze” pump action.
1. Flush detergent system by lifting cleaning tank lid,
removing tank from pressure washer and dumping
solution from tank.
2. Rinse cleaning tank out with fresh clean water. Fill tank
with clean water.
3. Run pressure washer with adjustable nozzle set for low
pressure. Flush for one or two minutes.
4. Dump remaining water out of cleaning tank. Push tank
back into pressure washer base. Reinsert detergent
hose and secure tank lid on tank.
5. Turn master ON/OFF switch to OFF and turn off water
supply. Point gun in a safe direction, press trigger lock
(red button) and squeeze trigger to relieve trapped
pressure. After a few moments, release trigger on spray
gun.
6. Disconnect hose from spray gun. Drain water from
hose, gun, and nozzle extension. Use a rag to wipe off
the hose.
7. Rewind high pressure hose onto hose reel.
8. Store unit in a clean, dry area that is protected from
freezing temperatures.
9. Cover unit with a suitable protective cover that does not
retain moisture.