Briggs & Stratton Electric Pressure Washer - Manual (Page 15)

15
Troubleshooting
Problem Cause Correction
Pump has following problems:
failure to produce pressure,
erratic pressure, chattering, loss
of pressure, low water volume.
1. Water inlet is blocked.
2. Inadequate water supply.
3. Inlet hose is kinked or leaking.
4. Clogged inlet hose strainer.
5. Water supply is over 100°F.
6. High pressure hose is blocked or
leaks.
7. Gun leaks.
8. Nozzle is obstructed.
9. Pump is faulty.
1. Clear inlet.
2. Provide adequate water flow.
3. Straighten inlet hose, patch leak.
4. Check and clean inlet hose strainer.
5. Provide cooler water supply.
6. Clear blocks in high pressure hose or
replace hose.
7. Replace gun.
8. Clean nozzle.
9. Contact Briggs & Stratton service
facility.
Detergent fails to mix with spray.
1. Adjustable nozzle is not in low
pressure position.
2. In-line detergent filter is dirty.
3. Turbo nozzle extension installed.
1. Pull adjustable nozzle back to low
pressure position.
2. Flush detergent filter with clean water.
3. Replace with adjustable nozzle
extension.