Briggs & Stratton Electric Pressure Washer - Manual (Page 7)

3. Run water through garden hose for 30 seconds to flush
the hose of debris. Turn off water.
4. Attach garden hose to water inlet coupling. Tighten by
hand.
IMPORTANT: DO NOT siphon standing water for the water
supply. Use ONLY cold water (less than 100°F).
5. Uncoil high pressure hose and attach quick connect
end of hose (A) to spray gun (B). Pull down on collar of
quick connect, slide on to spray gun and let go of
collar. Tug on hose to be sure of tight connection.
6. Attach nozzle extension to spray gun by aligning the
locking tabs (C) into the grooves in the gun (D). Push
extension inward and twist clockwise to lock in place.
Tug on connection to be sure it is securely attached.
7. Turn ON water, point gun in a safe direction, press
trigger lock (red button) (E) and squeeze trigger to
purge pump system and spray gun of air.
Checklist Before Starting Engine
Review the unit’s assembly to ensure you have performed all
of the following.
1. Be sure to read the Operator Safety section and How to
Use Your Pressure Washer in Operation section before
using pressure washer.
2. Make sure handle is in place and secure.
3. Check for properly tightened hose connections.
4. Check to make sure there are no kinks, cuts, or damage
to high pressure hose.
5. Provide a proper water supply at an adequate flow.
7
B
A
C
D
E
NOTICE
Damage to pump or water inlet connector will occur if a
One Way Valve (vacuum breaker or check valve) is
connected to pump.
• There MUST be at least ten feet (3M) of unrestricted garden
hose between the pressure washer inlet and any device, such as
a One Way Valve.
• Damage to equipment caused by attaching a One Way Valve to
pump will void warranty.
WARNING
Risk of eye injury.
Spray can splash back or propel objects.
• Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
• Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
• NEVER substitute safety glasses for safety goggles.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER connect high pressure hose to nozzle extension.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• Always be certain spray gun, nozzles and accessories are
correctly attached.