Binatone ACTION 950 - Manual (Page 3)

%DWWHU\ PHWHU
%DWWHU\ OLIH
d. Place the Action 950 units in the charge cradle in an upright position.
The Charge LED indicators will light up.
completely run down. New batteries take up to 14 hours to fully
charge.
e. It takes about 10 hours to fully recharge the batteries if they are
Important:
Always turn off the PMR units
when charging. This will
shorten the charging time.
Mains socket
OR: Charging the batteries (using adaptor)
Lift the charge socket cover located on
the right side of the handset.
Insert the round connector of
the 9.0V DC/200mA adaptor
into the charge jack.
Plug the mains adaptor into a
240V AC, 50Hz main socket
with the switch on the socket
set to OFF.
Use only the mains
adaptor provided.
Then switch ON the mains socket.
Mic/Earpiece jack
Charge jack
The battery meter is located in the left corner of the LCD Screen. It
appears like a battery with three bars inside. These indicate the
amount of power available. When the battery level reaches its
minimum level in PMR on mode, the unit will emit two beep tones
and automatically power off.
The Action 950 can detect the battery charge in 4 levels;
Battery charge at high level.
Battery charge at medium level.
Battery charge at low level. At this level, the Action 950 will
Important: Charge the unit for 10-14 hours.
Battery charge at very low level. When the battery level
reachs its minimum level in Action 950 on mode, the unit will
Important: Charge the unit for 10-14 hours.
CAUTION : Risk of explosion if battery is replaced by an
incorrect type. Dispose of used batteries according to the
instructions.
The Action 950 h as a built in power saver to make the batteries
Keep the out of the reach of babies and young children. Terrain 550
emit a “beep” sound for every 10 seconds in normal mode.
emit two beep tones and automatically turn off the
power .
last longer. But when you are not using the units, turn them
OFF to conserve battery power.
c ll a