Billion Electric Company 7202 - Manual (Page 11)

2.4The Rear Ports
myGuard 7202
3 4
1 2
myGuard 7202G
4 3
5
1
2
Port Description
1 PWR Connect the supplied power adapter to this jack.
2 RESET
After the myGuard router is powered on, press this recessed
button using the end of paper clip or other small pointed object to
reset the router or to restore it to factory default settings.
1. Recovery procedures for non-working routers (e.g. after a
failed firmware upgrade flash):
Hold the Emergency/Failure Recovery Button on the back of the
modem in. Keep this button held in and turn on the modem. Once
the lights on the modem have stopped flashing, release the
Emergency/Failure Recovery Button. The modem's
emergency-reflash web interface will then be accessible via
http://192.168.1.254/ where you can upload a firmware image to
restore the modem to a functional state. Please note that the
modem will only respond via its web interface at this address,
and will not respond to ping requests from your PC or to telnet
connections.
2. Recovery procedures for a lost web interface password:
After turning the router on press the Emergency/Failure
Recovery Button on the back of the modem, and hold the button
in until all lights on the modem flash and it reboots with factory
default settings. The login will be reset to admin and the
9