Brother PR-600 - Manual (Page 220)

Troubleshooting 201
7
The installed embroidery frame
is too small.
Check which embroidery
frames can be used, and then
install a larger embroidery
frame. (Refer to page 28.)
The embroidery data cannot be
detected.
The embroidery data may be
damaged.
Embroidery data with an
incompatible version is being
used.
Embroidery data that is not
complete or has an unknown
version cannot be used.
Characters have been com-
bined until they extend out of
the embroidery frame.
Decrease the number of charac-
ters so that they fit within the
embroidery frame.
Sewing cannot begin from the
specified starting position.
Change the starting position or
move the frame and change the
embroidering position. (Refer to
page 87.)
Another operation was per-
formed while the automatic
needle-threading mechanism
was threading the needle.
Press the automatic needle
threading button, and then per-
form the other operation after
the needle is threaded. (Refer to
page 39.)
Thread color that was specified
is incorrect.
The thread color number that
was entered is not in the custom
thread table setting. Check the
number, and then try entering
the number again.
Six manual needle bar settings
were being specified.
No more than five needle bars
can be specified.
Sapphire.book Page 201 Friday, August 1, 2003 9:12 AM