West Bend Back to Basics blender solution 4000 - Manual (Page 8)

8
Glass Mixing Jar
Lid
Rubber Gasket
Blender Blade Base
Clear Lid Cap
Use and Care (Assembly)
To use your Blender Solution ™ 4000, begin by assembling the glass mixing jar.
1. Position the rubber gasket down onto the circular fl at surface in the
plastic blender or smoothie blade base.
2. Place the bottom threaded section of the glass mixing jar down into the
plastic blade base. Engage threads by twisting the blade base clockwise
until tightened onto the jar. Make sure that the blade base is tightly fastened
to the jar and that the rubber gasket is properly compressed between the jar
and the plastic blade base.
3. Push the lid onto the top of the mixing jar. Place the clear lid cap in the
center of the lid or place the stir stick through the center of the lid.
4. Place the mixing jar onto the motor base so that the bottom of the blade
base is sitting fl at on the motor base.
5. Plug in the cord. Your Blender Solution ™ 4000 is now ready to use!
ASSEMLY