Brother DCP-J125 - Manual (Page 51)

Troubleshooting
37
B
Ink Absorber Full The ink absorber box or flushing
box is full. These components
are periodic maintenance items
that may require replacement
after a period of time to ensure
optimum performance from your
Brother machine. The need to
replace these items and the time
period before replacement is
dependent on the number of
purges and flushes required to
clean the ink system. These
boxes acquire amounts of ink
during the different purging and
flushing operations. The number
of times a machine purges and
flushes for cleaning varies
depending on different
situations. For example,
frequently powering the machine
on and off will cause numerous
cleaning cycles since the
machine automatically cleans
upon power up. The use of
non-Brother ink may cause
frequent cleanings because
non-Brother ink could cause poor
print quality which is resolved by
cleaning. The more cleaning the
machine requires the faster
these boxes will fill up.
Note
Repairs resulting from the
use of non-Brother supplies
may not be covered under
the stated product warranty.
The ink absorber box or flushing box will
need to be replaced. Contact Brother
Customer Service or a Brother Authorized
Service Center to have your machine
serviced. (See Brother numbers
on page i.)
Other reasons for cleaning are:
1 Machine automatically cleans after
clearing a printer jam.
2 Machine automatically cleans after
sitting idle for more than 45 days
(infrequent use).
Ink Absorber NearFull The ink absorber box or flushing
box is nearly full.
The ink absorber box or flushing box will
need to be replaced. Call Brother
Customer Service or a Brother Authorized
Service Center to have your machine
serviced. (See Brother numbers
on page i.)
Ink low One or more of the ink cartridges
are near the end of their life. Order a new ink cartridge. You can
continue printing until the LCD shows
Cannot Print. (See Ordering
accessories and supplies on page ii and
Replacing the ink cartridges on page 32.)
Low Temperature The print head is too cold. Allow the machine to warm up.
Error Message Cause Action