BUSH 1080P - Manual (Page 23)

P.22 BUSH | 1080p Digital LED LCD | User Manual | Helpline: 0845 604 0105
Size V
Pressing the button changes between full screen top
half bottom half full screen. This feature is very useful as
it magnifies the image making the characters easier to
read.
Reveal V
Pressing the button will reveal hidden text. This
feature is used to reveal information such as answers to
Teletext on-line interactive puzzles.
Time V
While in normal TV mode only, pressing the button
will display the teletext time in the top right hand corner
for a few seconds.
Fast text coloured V buttons
Fast text automatically displays the four most commonly
used pages that the broadcaster thinks that you may
want to choose next. Press the same coloured button on
the remote control as the coloured link at the bottom of
the teletext page to go directly to that page.
Subcode V
Pressing the button by entering its 4-digit number to
enter a secondary page.
USB MODE
Note
The diagrams in the following section are schematic O
and only for your reference. Please see the actual
product if necessary.
TO USE THE USB DEVICE
Supported file formats:
A
Photo: *.jpg; t

Music: *.mp3 files; t

Movie: *.avi files; t

TEXT: *.txt t

Note
Due to the particularity of file cording, some files O
may be unable to read.
Supported equipment:
B
Support the equipment that supports Mass Storage
Protocol and whose file system is FAT32, such
as some USB disks, mobile harddisks, and MP3
player. If USB equipment could not be identified
due to unsupported file system, please format the
equipment to the above-mentioned file system.
To achieve smooth playing, ensure the following:
C
The file code rate should be lower than 300KB/S; t

Due to the limitation of USB signal transmission t

distance, it is recommended not to use USB patch
cord, in case of using the cord, make sure that its
length is not over 1m;
Use high-speed USB equipment in conformity
t

with USB2.0 full speed Interface Standard; If USB
equipment in conformity with USB1.1 full speed
Interface Standard is used, the playing may be
unsmooth.
When connecting/removing the USB
device
Press “
A
SOURCE” on the remote control unit to select
USB option.
Insert USB equipment into corresponding USB
B
interface 2s after starting the system.
After entering the system menu, press “
C
/“ on the
remote control unit to select the require USB files,
press “OK” button to confirm the selection and enter
the file list relative to the selection.
Press
D
“/“ on the remote control unit to select the
required file, press “OK” button to enter the selected file.