Philips 27PC4326-37 - Manual (Page 36)

TV/VCR/DTV
36 Rerecording (Tape Duplication)
• Unauthorized recording of
copyrighted television
programs, videotapes or other
materials may infringe on the
rights of copyright owners and
violate copyright laws.
• Different brands of equipment
may operate differently.
• Make sure all connections are
secure. Otherwise, you may
not record both picture and
sound.
• Programs that are copyright
protected may not record
clearly.
• You cannot record a DVD
onto a videotape using this
TV/VCR/DVD.
• You can use this connection
to simply view tapes playing
on a camcorder or VCR at the
TV/VCR/DVD. Follow steps
1,
2 and 4 for connections and
AUX setup. Then play the tape
on the camcorder, etc., as
usual.
1 Make the connections shown above. Use audio
and video cables (not supplied). Connect the
source unit (VCR or Camcorder) to a power
source after connections are made.
2 The VCR or Camcorder will play your tape. Insert a
prerecorded tape in the source unit. If playback
begins, press STOP C on the VCR or Camcorder.
3 The TV/VCR/DVD will record your tape. Insert a
blank videotape in the cassette compartment
of the TV/VCR/DVD. Make sure the tape’s record
tab is intact and the TV/VCR/DVD power is on.
4 Point the TV/VCR/DVD remote control at the
TV/VCR/DVD. Press SELECT or CH. o/p until
AUX appears on the screen. The TV/VCR/DVD is
now in line input or auxiliary mode.
5 Press REC MODE until the desired tape speed
(SP or SLP) appears in the lower left corner of
the screen.
6 Press PLAY B on the VCR or Camcorder and
REC/OTR I on your TV/VCR/DVD at the same
time. Videotape copying will begin.
7 To stop copying, press STOP/EJECT C A on the
TV/VCR/DVD, then stop the tape on the VCR
or Camcorder.
VIDEO HEADPHONE L - AUDIO - R
VIDEO
OUT
L
AUDIO
OUT
R
AUDIO and VIDEO OUT Jacks on the source unit
(VCR or Camcorder)
AUDIO and VIDEO IN Jacks on
the front of TV/VCR/DVD
Audio Cables from
AUDIO OUT to AUDIO IN
Video Cable from
VIDEO OUT to VIDEO IN
Helpful Hints
T3221UB_EN1 4/20/06 9:32 PM Page 36