Philips 241P4QPYES-00 - Manual (Page 46)

44
11. Troubleshooting & FAQs
11. Troubleshooting & FAQs
11.1 Troubleshooting
This page deals with problems that can be
corrected by a user. If the problem still persists
after you have tried these solutions, contact
Philips customer service representative.
Common Problems
No Picture (Power LED not lit)
‡ Make sure the power cord is plugged into
the power outlet and into the back of the
monitor.
‡ First, ensure that the power button on the
front of the monitor is in the OFF position,
then press it to the ON position.
No Picture (Power LED is White)
‡ Make sure the computer is turned on.
‡ Make sure the signal cable is properly
connected to your computer.
‡ Make sure the monitor cable has no bent
pins on the connect side. If yes, repair or
replace the cable.
‡ The Energy Saving feature may be activated
Screen says
Attention
Check cable connection
‡ Make sure the monitor cable is properly
connected to your computer. (Also refer to
the Quick Start Guide).
‡ Check to see if the monitor cable has bent
pins.
‡ Make sure the computer is turned on.
AUTO button doesn't function
‡ The auto function is applicable only in
VGA-Analog mode. If the result is not
satisfactory, you can do manual adjustments
via the OSD menu.
Note
The Auto Function is not applicable in DVI-
Digital mode as it is not necessary.
Visible signs of smoke or sparks
‡ Do not perform any troubleshooting steps
‡ Disconnect the monitor from mains power
source immediately for safety
‡ Contact with Philips customer service
representative immediately.
Imaging Problems
Image is not centered
‡ Adjust the image position using the “Auto”
function in OSD Main Controls.
‡ Adjust the image position using the Phase/
Clock of Setup in OSD Main Controls. It is
valid only in VGA mode.
Image vibrates on the screen
‡ Check that the signal cable is properly
securely connected to the graphics board
or PC.
9HUWLFDOÁLFNHUDSSHDUV
‡ Adjust the image using the “Auto” function
in OSD Main Controls.
‡ Eliminate the vertical bars using the Phase/
Clock of Setup in OSD Main Controls. It is
valid only in VGA mode.
+RUL]RQWDOÁLFNHUDSSHDUV
‡ Adjust the image using the “Auto” function
in OSD Main Controls.