Philips DVD701AT99 - Manual (Page 16)

16 PREPARATION
Connecting the power cord
1 Plug the female end of the supplied power cord into the Mains (AC) jack
on the rear of the player.
2 Connect the other end of the cord to an AC outlet.
Note: When the player is in the “STANDBY” mode, it is still consuming some
power. If you wish to disconnect your player completely from the power, press
POWER ON/OFF
Caution: Only qualified service personnel should remove the
cover or attempt to service this device.
Remote control battery installation
Loading the batteries
1 Open the battery compartment cover.
2 Insert batteries as indicated inside the battery compartment.
3 Close the cover.
Caution: Do not mix old and new batteries. Never mix
different types of batteries (standard, alkaline, etc.).
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to match the
video signal of your TV.This setting only affects the television’s on-screen
display that shows the stop and setup modes.You may select either
NTSC or PAL.To change the DVD player setting to PAL or NTSC,
follow the steps below.
1 Press the POWER ON/OFF button on the front panel of the DVD
player to turn OFF the DVD player.
2 Press and hold / and T on the front of the DVD player.While
holding / and T, press POWER ON/OFF.
3 After PAL or NTSC appears on the display panel of the DVD player,
release / and T at the same time.The PAL or NTSC that appears on
the display panel indicates the current setting.
4 To change the setting, press T within three seconds.The new setting
(PAL or NTSC) will appear on the display panel.
+ - + -