Philips 32PT842H - Manual (Page 43)

43
N ow that you have looked up the four-digit
remote-control Direct-entry Code for
your brand of accessory device, you are ready
to follow the simple steps shown below to
program your TV remote.
Please read through all the steps before
beginning.
1 First, press and hold down the VCR
or ACC (for an accessory device
other than a VCR) mode button on
the TV remote. Then press and hold
down the MENU/SELECT button at
the same time for a brief moment.
Release the buttons. The TV remote
back light will switch on.
NOTE: For correct operation, you must
first press and hold the mode button and
then press and hold the MENU/SELECT
button simultaneously.
2 Within 30 seconds of pressing the
VCR (or ACC) button and
MENU/SELECT button, enter a
four-digit code for the accessory
device (see pages 45 and 46).
If you make a mistake while attempt-
ing to enter the four-digit code and
want to start again, press any button
other than one with a number. Then
return to step 1 to begin again.
3 Point the remote at the accessory
device. Then press the POWER button
on the remote to turn the device on.
U
SING THE
R
EMOTE WITH
A
CCESSORY
D
EVICES
- C
ODE
E
NTRY
If you do not enter a complete code within
30 seconds, you will need to perform step 1
of the Code-entry Method again.
If the procedure explained above does not
work the first time, repeat the steps using
the same remote code number.
If after repeated attempts the Code-entry
Method does not allow you to work your
accessory device with your TV remote, try
the Search Method explained on the next
page.
H
ELPFUL
H
INT
Cable Converter Box
Satellite Receiver
VCR
DVD Player
1
1
3
2