Philips VOIP4332B-37 - Manual (Page 11)

11
US
1. Insert the plug of the power cord into the socket on the bottom of
the base unit then plug the power supply unit into your power outlet.
2. Connect the telephone line cord to the phone socket on the bottom
of the base unit and to the wall phone socket.
3. Each handset comes with a charger and adapter. Insert the plug of the
power cord into the socket on the bottom of the charger. Plug the
power supply unit into your power outlet.
4. To remove the battery compartment, unlock the battery door lock at
the bottom of the handset.
5. Place the 2 rechargeable NiMH AAA batteries (included), observing
their polarities, into the battery compartment on the handset.
6. Slide the battery door firmly into place until the battery door locks.
7. Please note that handset may not turn ON for up to 15 minutes if the
batteries are too low. Before first use, put the product on the charger
and charge batteries for 24 hours minimum. The handset may get
warm during the initial charge. This is normal.
Note : *You may find in the box the line adaptor delivered
separately from the line cord. In this case, please, first plug this line
adaptor onto the line cord before connecting it to the line socket.
Note : The base station or charger must always be plugged into the
mains when charging or when in use. Always use rechargeable
batteries.
The warranty does not apply to the batteries and any other
components which have a limited lifetime or are exposed to wear.
Note : Always use the line cable and the adapters provided with the
product.
Connect