Problem solving – Philips DMVC300K-37 User Manual

Page 29

Advertising
background image

7. Problem solving

If a fault occurs, first check the points listed below. If you are unable to
remedy a problem by following these hints, contact the helpline
(see ‘Helpline’) or consult your dealer.
Never try to open the camera yourself as this will void the guarantee.

First, check all cables to ensure that they are connected correctly.

Problem

Possible cause / Solution

No photo is taken

Battery exhausted

while the Shutter • Recharge battery. See ‘Recharging the battery.
button is pressed

Memory full

all the way down

Transfer photos/video recordings to your PC or clear photos in order to
create memory space. See ‘Transferring/viewing photos and video
recordings’ and/or ‘Clearing photos and video recordings’.

Camera is still connected to the PC’s USB port

Disconnect the camera from the PC’s USB port or take the camera out
of its desktop stand.

Poor light conditions

Try to improve light conditions.

Camera turned off automatically (no button pressed for 60 seconds)

Turn the camera back on. See ‘Turning the camera on and off ’.

No reaction

Battery exhausted

to controls

Recharge battery. See ‘Recharging the battery.

File transfer not

USB cable not properly connected

possible

Properly connect USB cable to both desktop stand and PC and make
sure the camera is placed on the desktop stand.

USB driver not installed

Install USB driver and ‘Philips Photo Manager’ on your PC.

Not all images

The RAM memory installed in your computer may not have

can be transferred

sufficient storage space.

to the PC

Close all software programs and proceed to transfer your images. If the
problem persists, transfer images in batches and store each batch on
your hard drive before proceeding to the next batch. Make sure all the
images you want are stored before you clear the camera memory.

Camera

Check if the camera power is turned on. If not, turn it on and then

connected to PC

connect the camera to the PC again by placing it on the desktop stand.

but the Philips FunCam
driver says:
‘Device not ready’.

ENGLISH

29

DMVC300K_Fun_01 Eng.1.qxd 25-03-2004 12:45 Pagina 29

Advertising