Preparations – Philips MCD288-37 User Manual

Page 22

Advertising
background image

22

English

Preparations

IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.

Step 1: Inserting batteries into

the Remote Control

1

3

2

1

Open the battery compartment.

2

Insert two AAA batteries following the
indications (+/-) inside the compar tment.

3

Close the cover.

Using the Remote Control to operate

the Player

1

Aim the Remote Control
directly at the remote sensor
(IR) on the front panel.

2

Do not put any objects between
the Remote Control and the
DVD Player while operating the
DVD Player.

CAUTION!
–
Remove batteries if they are
exhausted or if the Remote Control is
not being used for a long time.
–
Do not use old and new or different
types of batteries in combination.
–
Batteries contain chemical substances,
so they should be disposed of properly.

Step 2: Setting the clock

1

Go to Standby mode.

2

Press and hold CLOCK on the remote.

➜

“

CLOCK SET” is displayed briefly. Then, the

hour digits flash on the display screen.

3

Press VOLUME -/+ (VOL +/- on the remote)
to set the hours.

4

Press CLOCK again.

➜

The minute digits flash on the display screen.

5

Press VOLUME -/+ (VOL +/- on the remote)
to set the minutes.

6

Press CLOCK to confirm the clock setting.

Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.

pg001-pg025_MCD288-37-Eng-A

2006.3.15, 16:51

22

Advertising
This manual is related to the following products: