Braun 34443 User Manual
Page 34
Page 32
1. Connect chair
hook to a solid
frame member of
the wheelchair (as
shown in Photo E).
2. Position and
connect belt keeper
fitting (attachment)
to appropriate track
anchorage point
(slots). Attach
keeper as detailed
on page 29.
Pull firmly on belt
to ensure fitting is
locked in track.
Note: Belt angles
should be as shown
in Figure 2 on page
28.
E
F
G
H
3. With buckle open,
pull loose end of belt
until tight (see Photo
G). While holding
the loose end with
one hand, close the
lever of the clamp
(buckle) down until it
locks. See Photo H.
4. Connect Velcro
™
tabs to keep excess
belt off floor. See
Photo I).
Repeat procedures
for all belts.
Note: Check to see
that front and rear
belts are tight and
the chair is secure
enough that it does
not have any move-
ment. Lock wheel-
chair brakes.
Over-Center Belt
Attachments
I
J
Belt Release: Press
lever clamp (lock) to
release tension on belt.
Keeper
Hook
WHEELCHAIR AND OCCUPANT RESTRAINT
Velcro
™
Tabs