Braun 34443 - Manual (Page 55)

Page 53
Fuse Blocks: Two fuse blocks
are provided for use as an auxil-
iary power source (one Ignition
fuse block and one Battery fuse
block).
The Battery fuse block provides
power at all times (independent of
the vehicle ignition). The Ignition
fuse block supplies power only
when the vehicle ignition is on.
The installer is responsible for
supplying the correct gauge wire
and fuse for the particular device
to be attached to the fuse block
(as specified by the manufacturer
of the device).
Ignition Fuse Block: The total
maximum load must not exceed
40 amperes.
Battery Fuse Block: The total
maximum load must not exceed
40 amperes.
Note: If installing an auxiliary
electrical device that requires
more than a 40 ampere power
source, an alternative power
source must be provided.
AUXILIARY POWER SUPPLY / BELOW FLOOR OBSTRUCTIONS
Fuse Block Access: The fuse
blocks are located at the bottom
of the center console. Remove
upper console panel (3 fasteners
per side). Remove lower panel.
Note: The fuse blocks are part
of the gateway electrical assem-
bly. Two grounding studs are
also provided.
OEM Fasteners
30
F3 F4
F1 F2
29428
F3 F4
F1 F2
29429
OPEN OPEN
OPEN OPEN OPEN
20 30
Under Dash Fuse Blocks