Changing the stitch density, Changing the pattern length, Caution changing the pattern length – Brother NX 600 User Manual
Page 126
UTILITY STITCHES
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
120
GETTING READ
Y
CONTENTS
SEWING BASICS
U
T
IL
IT
Y
S
T
ITCHES
APPENDIX
INDEX
Changing the stitch density
If a decorative satin stitch has been selected, the
stitch density can be changed.
a
Select a decorative satin stitch
.
b
Press
(Settings key) in the operation panel.
X
The settings screen appears.
c
Press
,
,
and (Arrow keys) until
is selected.
d
Press
(OK key).
X
The screen for specifying the stitching
density of the decorative satin stitch appears.
e
Press
and until the desired density is
selected.
Select
for coarser stitching or select
for
finer stitching.
f
Press
(OK key).
X
The initial stitch screen appears again, and
the stitching density is changed.
CAUTION
Changing the pattern length
The length of one part of a satin stitch can be set to
one of five sizes.
a
Select a satin stitch
.
b
Press
(Settings key) in the operation panel.
X
The settings screen appears.
c
Press
,
,
and (Arrow keys) until
is selected.
d
Press
(OK key).
X
The screen for changing the length of a satin
stitch appears.
e
Press
and until the desired ratio is
selected.
The length can be set within the range of
and .
X
The satin stitch length is changed.
f
Press
(OK key).
X
The initial stitch screen appears again.
● If the stitching density is too fine,
depending on the needle, the stitches may
be bunched together, causing the needle
to break.