Brother NX 600 - Manual (Page 79)

Basic Stitching 73
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
GETTING READ
Y
CONTENTS
SEWING BASICS
U
T
IL
IT
Y
S
T
ITCHES
APPENDIX
INDEX
Basic stitching
a
Baste or pin together the fabric pieces.
b
Attach zigzag foot "J".
• For details, refer to "Replacing the presser
foot" (page 37).
c
Select a stitch.
• For details, refer to "Selecting stitching" (page
66).
d
Lower the needle into the fabric at the
beginning of the stitching.
e
Start sewing.
• For details, refer to "Starting to sew" (page
48).
• For details on sewing reverse/reinforcement
stitches, refer to "Securing the stitching" (page
50).
f
When sewing is finished, cut the thread.
• For details, refer to "Cutting the thread" (page
51).
■ Changing the needle position
The needle position used as the baseline is
different for the straight stitch (left needle
position) and the straight stitch (center needle
position).
a Straight stitch (left needle position)
b Straight stitch (center needle position)
When the stitch width of the straight stitch (left
needle position) is set to its standard setting
(0.0 mm), the distance from the needle position to
the right side of the presser foot is 12 mm
(1/2 inch). If the stitch width is changed (between
0 and 7 mm (1/4 inch)), the needle position will
also change. By changing the stitch width and
sewing with the right side of the presser foot
aligned with the edge of the fabric, a seam
allowance can be sewn with a fixed width.
a Stitch width
b Distance from the needle position to the right side
of the presser foot
c 12.0 mm (1/2 inch)
d 10.0 mm (3/8 inch)
e 6.5 mm (1/4 inch)
f 5.0 mm (3/16 inch)
• For details, refer to "Adjusting the stitch width"
(page 55).
J
1 2
0.0 2.0 5.5 7.0
1
6 5 4 3
2