Philips TD4454Q-37 - Manual (Page 14)

Getting started 12
After around 30 seconds, your phone will go
back to WELCOME screen for you to select
the country again.
3.5 How to power off or on the
handset power
You can power off your handset in order to
save battery power.
Press and hold for about five seconds to
power off the handset
Press
to power on the handset again 2
1
Place the batteries as indicated in the
battery compartment and replace the
battery cover.
3.3 Place the handset on the charging
cradle
When the battery is fully charged, the talk time
of your phone is approximately 12 hours and
the standby time is approximately 150 hours.
Place the handset on the charging cradle of
the base station
Leave it there until the batteries are fully
charged
When the handset is fully charged,
is
displayed
3.4 Configure your phone
Depending on your country, the WELCOME
screen may not appear. In that case, you do not
need to select the country code to configure
your phone.
Before using your phone, you need to configure
it according to the country of use. After
charging it for a few minutes, the WELCOME
screen appears. Follow these steps to configure
your phone :
Press to display the list of countries
• Available country will display on the screen.
Note
If is pressed, the handset will show the
WELCOME screen again.
Press / to scroll to your country
Press to confirm your selection
• Your phone is configured according to your
selected country and back to idle screen.
Note
Once the country is selected, the default line
settings for the selected country will be applied
to your phone automatically.
Tip
If you chose the country in use wrongly or
would like to change the country after the first
configuration, you can press
in idle mode to
enter into the main menu, then input ##**793
to reset to default settings.
3
2
1
3
2
1
2