Troubleshooting – Philips 190EL1SB-00 User Manual
Page 9
Troubleshooting
Troubleshooting
This page deals with problems that can be corrected by a user. If the problem still persists after you have tried these
solutions, contact Philips customer service representative.
Common Problems
Having this problem
Check these items
No Picture
(Power LED not lit)
●
Make sure the power cord is plugged into the power outlet
and into the back of the monitor.
●
First, ensure that the power button on the front of the monitor
is in the OFF position, then press it to the ON position.
No Picture
(Power LED is Orange)
●
Make sure the computer is turned on.
●
Make sure the signal cable is properly connected to your
computer.
●
make sure the monitor cable has no bent pins on the connect
side. If yes, repair or replace the cable.
●
The Energy Saving feature may be activated
Screen says
●
Make sure the monitor cable is properly connected to your
computer. (Also refer to the Quick Set-Up Guide).
●
Check to see if the monitor cable has bent pins.
●
Make sure the computer is turned on.
AUTO button doesn't function in VGA
mode
●
The auto function is applicable only in VGA-Analog mode. If
the result is not satisfactory, you can do manual adjustments
via the OSD menu. Note that the Auto Function is not
applicable in DVI-Digital mode as it is not necessary.
Imaging Problems
Image is not centered
●
Press the Auto button.
●
Adjust the image position using the Phase/Clock of Setup in
OSD Main Controls.
file:///E|/manual SPEC/813/spec/cd/19/Q70G19C1813 2A 190EL1/CD/lcd/manual/ENGLISH/190E1/safety/saf_troub.htm（第 1／3 页）2010-1-11 16:34:33