Philips Norelco SensoTouch wet and dry electric razor 1190XD DualPrecision heads Jet Clean 50 min with Precision trimmer and Jet Clean system - Manual (Page 8)

15 14
ENGLISH
◗ Remaining Battery Capacity
C
Models 1190X, 1180X, 1180XCC
-The remaining battery capacity is indicated by
the number of charging lights that are on.
◗ Low Battery Indicator
C
Models 1190X, 1180X, 1180XCC
-When the battery is almost empty (5 or less
shaving minutes left), the bottom charging light
blinks orange. When you turn the razor OFF the
bottom charging light continues to blink for a few
seconds.
C
Models 1160X, 1160XCC and 1150X
-When the battery is almost empty (5 or less
shaving minutes left), the plug symbol blinks.
When you turn the razor OFF the plug symbol
blinks for a few seconds.
NOTE: The displays of models 1160X, 1160XCC
and 1150X look different, but work the same way.
◗ Replacement Shaving Unit Indicator
C
Every year, depending on your shaving behavior,
after turning the razor OFF, the replacement
shaving unit symbol indicator starts to blink.
The replacement reminder is repeated at 9
successive shaves or until you reset the razor.
This reminds you that with new shaving heads
you will guarantee yourself optimal shaving
performance.
ENGLISH
◗ Travel Lock
The razor is equipped with a travel lock
function. You can use the travel lock function
when you are going to store the razor for a
longer period or if you are going to take the
razor with you when traveling. See ‘Travel Lock’
section for instructions on how to use this
function.
Charge Meter
(1190X/1180X/1180XCC)
◗ Charge Meter monitors amount of remaining
battery power available. Remaining battery
capacity is based on the amount of power
consumed shaving per minute and is
dependent upon your skin and beard type,
whether you use pre-shave lotion, and how
often the trimmer is used.
◗
Initially your razor may need to go through
2 or 3 full charge/recharge cycles before
remaining battery capacity indicators begin
to display your accurate battery power left.
Before First Use
◗
Charge the razor before you start using
it (see ‘Charging’). Make sure the razor is
switched off before you start charging it.
◗ Remove any sticker or protective foil from
the Display before using razor.