Philips 25PT533S-17 - Manual (Page 7)

7
ANT 75‰
L/Mono
Monitor out VIDEO
S-VIDEO
AV1 in Y Pb Pr
AV2 in
AUDIO R COMPONENT VIDEO INPUT
1
Y our Cable TV input into your home may
be a single (75 ohm) cable. If so, this con-
nection is very simple. Follow the steps below
to connect your cable signal to your new tele-
vision.
Direct Cable Connections:
1 Connect the open end of the round
Cable Company supplied cable to the
75
Ω input on the TV. Screw it down fin-
ger tight.
B
ASIC
C
ABLE
T
ELEVISION
C
ONNECTION
BACK OF TV
Direct Cable Connection:
Cable signal coming
from Cable
Company (Round
75 Ω coaxial cable)
Jack Panel Back of TV
A combination antenna receives normal
broadcast channels (VHF 2–13 and
UHF 14–69). Your connection is easy
because there is only one 75
Ω (ohm)
antenna plug on the back of your TV, and
that’s where the antenna goes.
1 If your antenna has a round cable
(75 ohm) on the end, then you're ready
to connect it to the TV.
If your antenna has flat, twin-lead
wire (300 ohm), you first need to
attach the antenna wires to the screws
on a 300- to 75-ohm adapter.
2 Push the round end of the adapter (or
antenna) onto the 75 Ω (ohm) plug on
the back of the TV. If the round end of
the antenna wire is threaded, screw it
down finger tight.
B
ASIC
A
NTENNA
T
ELEVISION
C
ONNECTION
After using the AutoProgram Control, press
the CH + and – buttons to scroll through all
the channels stored in the television’s memory.
c c C
HECK
I
T
O
UT
1
2
ANT 75‰
L/Mono
Monitor out VIDEO
S-VIDEO
AV1 in Y Pb Pr
AV2 in
AUDIO R COMPONENT VIDEO INPUT
Back of TV
Round 75 Ω
Coaxial Cable
from Antenna
Twin
Lead Wire
300 to 75-ohm
Adapter
Outdoor or Indoor Antenna
(Combination VHF/UHF)
The combination antenna receives normal
broadcast channels 2-13 (VHF) and 14-69 (UHF).
Antenna Connection:
Jack Panel
Back of TV