Philips DVD624AT99 - Manual (Page 38)

38 SPDIF, LPCM 96K Setup
LPCM 96K Setup
If you connected the DVD Player to a Stereo using the OPTICAL or COAXIAL
jack as shown on page 14, you may need to adjust the LPCM 96K setting.
Discs are recorded in a certain sampling rate. (The higher the sampling rate, the
better the sound quality.) Some Discs are recorded in a high sampling rate of 96
kHz. Set LPCM 96K to ON if you want the DVD Player to detect the sampling
rate of Discs during playback and automatically choose the best sound available.
1 Press SYSTEM MENU.
2 Press 9 repeatedly to select SPDIF SETUP, then press
OK.
3 Press 9 to select LPCM 96K, then press -.
4 Press 8 or 9 to select OFF or ON, then press OK.
5 Press SYSTEM MENU to remove the menus.
SPDIF OUT
LPCM 96K
F OFF
ON
MAIN PAGE
- - SPDIF SETUP - -
SET LPCM OUTPUT AS 96K
1,5
2-4
SPDIF Setup
SPDIF is the Sony Philips Digital Interface, or a method of transferring digi-
tal audio. If you connected the DVD Player to a Stereo using the OPTI-
CAL or COAXIAL jack as shown on page 14, you need to adjust the
SPDIF OUT setting as described below. If you are not using the OPTICAL
or COAXIAL jack, no adjustment is necessary.
1 Press SYSTEM MENU.
2
Press 9 repeatedly to select SPDIF SETUP, then press
OK.
3 SPDIF OUT will be selected. Press -.
4
Press 8 or 9 to select RAW or PCM, then press OK. Choose RAW
to select the original default audio settings as received by most Stereos.
However, if the sound is distorted, your Stereo may need to receive audio in
the PCM (pulse code modulation) format. Choose PCM if your Stereo is
PCM-compatible. Refer to your Stereo owner’s manual for details.
5 Press SYSTEM MENU to remove the menus.
SPDIF OUT F RAW
LPCM 96K PCM
MAIN PAGE
- - SPDIF SETUP - -
RAW DATA VIA SPDIF
1,5
2-4