Assembly guide, Step 10 - attach the leg extension pivot tube – Bowflex Sport Home Gym User Manual

Page 13

Advertising
background image

11

Step 10 - Attach the Leg Extension Pivot Tube

Locate the following items:

Item #13 - Leg Extension Pivot Tube
• From Step 9 - Main Assembly
Item #30 - Lock Out Pin
Item #G - (1) 3/8" X 2 3/4" Button Head Screw
Item #N - (2) 3/8" Washers
Item #O - (1) 3/8" Nylock Nut
Item #Q - (1) Bolt Cover

Undo the twist ties from the Pivot Bushings. Align the holes
located on the “curve” of the Leg Extension Pivot Tube (Item #13)
with the holes on the bracket of the Rear Leg, as shown in Figure

10a.

Place (1) 3/8" Washer (Item #N) over the end of (1) 3/8" X

2 3/4" Button Head Screw (Item #G). Thread the screw

through the aligned holes and bushings and secure by

placing (1) 3/8" Washer and (1) 3/8" Nylock Nut (Item #O)

over the end of the screw, as shown in Figure 10a.

Do not over-tighten hardware from Step 10.

Place (1) Bolt Cover (Item #Q) over the Nylock Nut installed

during Step 10.

Note: When storing the Rail Assembly, insert the Lock Out Pin

(Item #30) through the holes in the Pivot Tube to temporarily

hold the Leg Extension in place while folding the Rail up (see
Figure 10b).

Figure 10a

13

N

O

G

Bracket

Rear Leg

“Curve”

Figure 10b

Holes

Leg

Extension

30

Assembly Guide

Advertising