Assembly guide, Step 2 - attach the base legs to the base platform – Bowflex Sport Home Gym User Manual

Page 7

Advertising
background image

5

Step 1 - Attach the Lower Lat Tower to the Base

Platform

Locate the following items:

Item #1 - Lower Lat Tower
Item #2 - Base Platform
Item #H - (4) 3/8" X 3" Button Head Screws
Item #N - (8) 3/8" Washers
Item #O - (4) 3/8" Nylock Nuts

Set the Base Platform (Item #2) onto the floor as shown
in Figure 1. Line up the bolt holes in the mounting channels

on the Lower Lat Tower (Item #1) with the holes in the Base

Platform tubes.

Place (4) 3/8" Washers (Item #N) over the ends of (4) 3/8" X 3"

Button Head Screws (Item #H) - one washer per screw.

Insert the forward screws through the bolt holes in the Lower

Lat Tower and Base Platform first, then tip the Base Platform

back to install rear screws. Place (4) 3/8" Washers over the

ends of the screws, one washer per screw, and secure using

(4) 3/8" Nylock Nuts (Item #O), as shown in Figure 1.

Completely tighten hardware installed during Step 1.

3

Figure 2

E

Base Platform/

Lower Lat

Tower

Assembly

N

Stems

Tube

Ends

Stems

Pulleys

4

2

Figure 1

H

N

O

Mounting

Channels

Base Platform

Tubes

Forward

Screws

1

Step 2 - Attach the Base Legs to the Base Platform

Locate the following items:

• From Step 1 - Base Platform/Lower Lat Tower Assembly
Item #3 - Base Right Leg - Do not unwrap cables!
Item #4 - Base Left Leg - Do not unwrap cables!
Item #E - (4) 3/8" X 3/4" Button Head Screws
Item #N - (4) 3/8" Washers

With the Base Platform/Lower Lat Tower Assembly (from
Step 1) on the floor, insert the stems from each Base Leg
into the tube ends on the Base Platform, as shown in

Figure

2

. Make sure to orient the 2 pulleys upward.

Carefully line up the two bolt holes on each Leg with the

corresponding holes on the Base Platform/Lower Lat Tower

Assembly.

Place (4) 3/8" Washers (Item #N) over the ends of (4) 3/8" X 3/4"

Button Head Screws (Item #E) - one washer per screw. Loosely

secure the Base Legs to the Base Platform Assembly with the

screws and washers as shown in Figure 2.

Completely tighten hardware installed during Step 2.

Assembly Guide

Advertising