Document Outline

• MAINTENANCE INSTRUCTIONS
• + WORKSHOP MANUALforWS - Single Pressure Pump
• RECOMMENDED SPARES
  • • • • • • • REAR WEAR RING
    • INSTALLATION
      • MAINTENANCE
• It is the responsibility of the user to ensure that the equipment is maintained in a safe operational condition, as per regulation 5 in the Provision and Use of Work Equipment Regulations 1998.
  • • • PUMP DRIVE AND PRIMING SYSTEMS
      • NOISE
      • THERMAL RELIEF VALVE
      • OPERATION
        • Engineering Director
      • LUBRICATION
    • PROTECTION AGAINST FROST
      • • • • Section 1
              • To Remove
            • Section 2
              • • WEARING RING MAINTENANCE
              • To Refit
                • SECTION 3
                • LOW PRESSURE IMPELLER AND REAR WEAR RING
              • To Remove
              • Maintenance
          • Fig 3-1Checking the wearing diameters of the low pressure impeller
            • • To Refit
              • Rear Wear Ring
      • Pump Type
        • • • • To Refit
• Re-assembly of the seal is completed as described below. Please note: Mechanical Seals are precision-engineered devices and extreme care must be taken to ensure that no damage occurs to the lapped faces.
  • • • • • • Section 5
• LOW PRESSURE MANIFOLD AND FILTER HOUSING
  • • • • • • • To Remove
              • Reassembly
              • Filter Housing
            • Section 7
              • To Remove End Covers
              • Reassembly
• Supplement for World Series Pump Maintenance – WT
  • • • • • • • To Remove
              • To Refit
            • Section 8
    • PUMP BODY
      • • • • • To Remove
              • To Refit
            • Section 9
    • FRONT END OIL SEAL AND WEAR RING
      • • • • • Refitting
            • Section 10
    • REAR END OIL SEAL AND WEAR RING
      • • • • • Refitting
            • Section 11
    • BEARING HOUSING
      • • • • • To Remove
              • To Rebuild