Hale FoamLogix 6.5 - Manual (Page 123)

123 FoamLogix 3.3 / 5.0 / 6.5 Installer / Operations Manual
p/n: 029-0021-68-0
Ope ra tion
❑
% Foam
Selecting % FOAM shows the
foam concentrate injection rate
setting.
For example, with a single tank
system or when the dual tank
system selector is in the TANK
“A” position the display shows A
0.5. When the dual tank system
selector is in the TANK “B” posi-
tion the display shows B 1.0.
(See Figure 5-2: “Function
Modes.”)
When the system includes an
MST, MDT II or ADT and the
selector is in the FLUSH position
the display reads FLUSH. (See
Figure 5-3: “Flush,” on page
125.)
Total Flow
Selecting TOTAL FLOW shows
the total amount of water or foam
solution pumped through flow
sensor monitored discharges.
This totalized value may be reset
- see heading 5.3 “Reset Func-
tions” on page 124.
Total Foam
Selecting TOTAL FOAM shows
the total amount of foam concen-
trate pumped.
The value is in the same unit of
measure as the water flow. This
totalized value may be reset -
see heading 5.3 “Reset Func-
tions” on page 124.
For example, the display may
show 9.5, indicating 9.5 gallons
(36 liters) of foam concentrate
have been used. (See Figure 5-2: “Function Modes.”)
Figure 5-2: Function Modes