Fluid Management VR-1 Mixer - Manual (Page 16)


Fluid Management Customer Service 1.800.462.2466 V-Series | 15
Frequently Asked Questions
Equipment troubleshooting
Most problems with the V-Series Mixer can be easily solved with a quick and easy solution. For instance, follow the
daily cleaning suggestions in the Maintenance, Care, and Use and the Getting to Know Your V-Series Mixer
section. Think about the conditions that led up to the problem. Making a note of things you did before the problem
occurred will help you narrow down possible causes and find the answers you need.
First, make sure:
• The power cords are securely connected to a working dedicated power source.
• The power button is on.
• You have followed the suggestions in the Maintenance, Care, and Use section.
• The machine is situated on a flat, level, and stable surface capable of supporting the weight of the machine.
Use the chart below to locate the problem, check the possible cause, and then take the action recommended.
Contact Fluid Management Customer Service if you are unable to find a resolution.
PR O B LE M FI R S T CH ECK AC T I O N
The mixer does not start.
The mixer will not shut off.
• Is mixer plugged in?
• Does “0” appear on led?
• Is voltage present?
• Is front door closed?
• Is motor overheated?
• Is time shown on led display
showing and counting down?
• Connect mixer to power source.
• Connect mixer to power source.
• Contact an electrician.
• Close front door.
• Allow motor to cool for at least
five minutes. Check for an
excessive accumulation of
dirt. Vacuum if necessary.
• Call customer service.
• Let mixer finish mixing cycle.
• Unplug mixer.
• Call customer service.
The motor has voltage and hums,
but it will not run.
An excessive amount of vibration
occurs.
The motor starts slowly.
• Is the line voltage low?
• Is the belt too loose or too tight?
• Is can holder empty?
• Is mixer level?
• Is one of adjustable legs
broken, low, or damaged?
• Is paint can positioned in
the can holder correctly?
• Is the belt tension too tight?
• Make sure the mixer is
on a dedicated line.
• Check the tension of the belt.
• Call customer service.
• Place container in can holder.
• Adjust legs until balanced.
• Replace or adjust damaged leg.
• Position container in the can holder.
• Adjust the tension of the belt.