Fluid Management H-5 Mixer Mechanical Timer - Manual (Page 17)

TROUBLE-SHOOTING CHART
H-5 Paint Mixer Operating & Instruction Manual 17
TROUBLE-
SHOOTING
CHART Using the chart below, locate the problem in the first column, then select the
probable cause to check and action to take from the next two columns. The
problems are arranged from the simplest to the most complex.
Where appropriate, refer to the Servicing and Repair section to correct the
problem.
PROBLEM CHECK ACTION
The paint mixer does not
start.
if mixer attached to power.
receptacle for voltage.
• Connect to power source.
• Contact electrician.
if the front door is not closed.
• Close the front door.
Motor overload may be tripped. • Allow motor to cool.
May be problem with printed circuit
board. • Call Customer Service.
• Replace printed circuit
board.
door limit switch.
• Replace as required.
Paint mixer will not shut
off.
timer control board.
• Replace if necessary.
if relay is stuck in the closed posi-
tion.
• Replace if necessary.
May be problem with printed circuit
board. • Call Customer Service.
• Replace printed circuit
board.
The shake motor has volt-
age and hums, but it will
not run.
for low line voltage.
• Confirm that the mixer is
on a dedicated line.
V-belt tension.
• Correct tension.
V-belt
• Replace as needed.
motor.
• Replace motor.