OR-Fab 84342 JK 4 DOOR REAR QUARTER ARMOR W/RAIL & MAXXIMA LAMPS - Manual

3651 N Highway 89 • Chino Valley, AZ 86323
(928) 636-7080 • www.p-a-g.net
JEEP WRANGLER,
RUBICON, UNLIMITED (JK)
QUARTER ARMOR KIT
INSTALLATION INSTRUCTIONS
84330 07-12 JK 2Dr. W/LED
84331 07-12
JK 2Dr. “RAW” W/O LIGHT HOLES
84332 07-12
JK 2Dr. W/RAIL BAR & W/LED
84340 07-12 JK 4Dr. W/LED
84341 07-12
JK 4Dr. “RAW” W/O LIGHT HOLES
84342 07-12
JK 4Dr. W/RAIL BAR & W/LED
WARNING
Before you install this kit, read and understand all
instructions, warnings, cautions, and notes in this
instruction sheet and in the vehicle owner’s manual.
CAUTION
Proper installation of this kit requires knowledge of the
factory recommended procedures for removal and
installation of original equipment components. We rec-
ommend that the factory shop manual and any special
tools needed to service your vehicle be on hand during
the installation. Installation of this kit without proper
knowledge of the factory recommended procedures
may affect the performance of these components and
the safety of the vehicle. We strongly recommend that
a certified mechanic familiar with the installation of sim-
ilar components install this kit.
WARNING
Always wear eye protection when operating power
tools.
WARNING
Before you install this kit, block the vehicle tires to pre-
vent the vehicle from rolling.
1 JEEP JK Quarter Armor Kit
Before Starting Installation
1. Carefully read all warnings and instructions com-
pletely before beginning.
2. Verify all parts have been received in this kit by
checking the parts list at the end of this document.
3. Only install this kit on the vehicle for which it is
specified. If anytime during the installation you
encounter something different from what is outlined
in the instructions, call technical support at (928)
636-7080.
4. Special tools needed:
a. Drill with 1/4” - 3/8” - 9/16” drill bits
b. Center punch
c. Allen Tool Set
d. C-clamp Vice Grip “wide Jaw”
e. Electrical Crimp Tool
f. Test Light
Recommend purchasing kit 2dr Rocker Armor (84310)
and installing this kit prior to quarter armor install. This
will insure proper alignment and fitment of quarter armor.
**Use a light amount of oil on kit button head bolts when
installing bolts into rivet to help prevent thread damage**
5. Park vehicle on a clean, dry, flat, level surface and
block tires so vehicle cannot roll in either direction.
Engine Compartment
1. Disconnect both battery cables. Disconnect nega-
tive cable first, then positive cable.
NOTE
Kit parts are prefaced by the word kit and appear in
bold print.
NOTE
If parts are missing from kit, please be prepared to pro-
vide the following information:
1. Name of purchase location
2. Bar Code on side of box
3. Date above bar code
4. Date inside box cover
5. Inspector # from inside box cover