JLG Telehandler Personnel Work Platform - Manual (Page 31)

Section 4 - Types of Personnel Work Platforms
4-1 31200160
SECTION 4 - TYPES OF PERSONNEL WORK
PLATFORMS
4.1 APPROVED PERSONNEL WORK PLATFORMS
Quick Switch Mounted - JLG Supplied
To determine if a quick switch personnel work platform is approved for use on the
specific telehandler you are using, perform the following prior to installation.
• The attachment model/option number on the attachment identification plate must
match the attachment number on a capacity chart located in the operator cab.
• The model on the capacity chart must match the model telehandler being used.
If any of the above conditions are not met, do not use the platform. The telehandler
may not be equipped with the proper capacity chart or the platform may not be
approved for the model telehandler being used. Contact JLG or the local distributor
for further information.
Fork Mounted
Fork mounted personnel work platforms must comply with the design requirements
of platforms for elevating personnel as outlined in the current revision of ITSDF
B56.6 Safety Standard for Rough Terrain Forklift Trucks.
Note: Compliance to OSHA regulations does not necessarily indicate compliance to
ITSDF B56.6.
If the platform does not meet the design requirements of the B56.6 Standard, do not
use the platform.
Contact JLG Product Safety Department at 1-877-554-7233 or the local distributor
for additional information.