JLG 544D-10 Operator Manual - Manual (Page 83)

Section 5 - Attachments
5-21 31200172
The joystick (1) controls lift/lower and extend/retract movement of the boom.
The tilt lever (2) controls the carriage tilt.
• Move lever back to tilt up.
• Move lever forward to tilt down.
To Side Tilt:
The auxiliary hydraulic lever (3) controls the carriage side tilt.
• Move lever up to (side) tilt left.
• Move lever down to (side) tilt right.
Installation Procedure:
• Refer to “Attachment Installation” on page 5-11.
Operation:
• Approach load with forks centered on load and stop telehandler.
• Level telehandler before side tilting carriage to engage load.
• Side tilt carriage to left or right to align forks with load and engage load.
• Raise load slightly and level carriage side to side.
• Travel in accordance with the requirements set forth in Section 1 - General
Safety Practices.
Equipment Damage Precautions:
• Do not use forks as a lever to pry material. Excessive prying forces could
damage forks or machine structure.
• Do not attempt to lift loads that are attached or connected to another object.
WARNING
CRUSH HAZARD. Do not use side tilt to push or pull objects or load. Failure to
comply could cause object or load to fall.