JLG 534D-10 - Manual (Page 165)

9.17 534D-9, 534D-10 & 544D
Electrical System
3. Connect the battery negative (-) cable at the negative
battery (-) terminal.
4. Start the machine and check the replaced switch for
proper function.
9.12.3 Warning or Activated Lights
1. Park Brake - Activated
2. Check Engine - Warning
3. Alternator - Warning
4. 4x4/4x2 - Activated
a. Bulb Removal
1. Remove the battery negative (-) cable at the negative
battery (-) terminal.
2. Pull the panel out of the dash, disconnect the wire
connector to the bulb in question and remove the
bulb from the panel.
b. Inspection and Replacement
Inspect the bulb terminals for continuity and/or shorting.
Replace a defective or faulty bulb with a new bulb.
1. Replace bulb in panel, connect wire and secure
dash panel.
2. Connect the battery negative (-) cable at the negative
battery (-) terminal.
9.13 Transmission Lever
9.13.1 Transmission Lever Replacement
a. Lever Removal
1. Remove the battery negative (-) cable at the negative
battery (-) terminal.
2. Loosen and remove the two allenhead screws
holding the lever together. Disconnect the wiring
harness connector from the lever base and remove.
b. Disassembly
DO NOT disassemble the shifter or wiper lever. Replace
a defective lever with a new part.
c. Inspection and Replacement
Inspect the switch terminals for continuity and shorting.
Replace a defective or faulty lever with a new lever.
d. Lever Installation
1. Connect the wire harness connector to the lever
base.
2. Install both allenhead screws into the transmission
shift lever base and tighten the two screws into the
wiper lever base.
3. Connect the battery negative (-) cable at the negative
battery (-) terminal.
4. Start the machine and check the functions of the
replaced lever.
e. Neutral Lock Lever
The red lever on the side of the transmission shift lever
base is the neutral lock. With the travel lever in neutral,
switch the neutral lock lever to the "N" position. This will
lock the travel select lever. Switch the neutral lock lever
to "D" to unlock the travel select lever.
9.14 Traction Lock Pedal
9.14.1 Traction Lock Pedal Replacement
a. Pedal Removal
1. Remove the battery negative (-) cable at the negative
battery (-) terminal.
2. Disconnect the wiring harness connector from the
pedal base.
3. Remove the two bolts holding the pedal and remove.
b. Disassembly
DO NOT disassemble the pedal. Replace a defective
pedal with a new part.
c. Inspection and Replacement
Inspect the switch terminals for continuity and shorting.
Replace a defective or faulty pedal with a new pedal.
d. Pedal Installation
1. Connect the wire harness connector to the pedal
base.
2. Install both bolts and tighten base.
3. Connect the battery negative (-) cable at the negative
battery (-) terminal.
4. Start the machine and check the function of the
replaced pedal.