2 extend/retract cylinder installation, Extend/retract cylinder installation – JLG 534D-10 User Manual
Page 47
Advertising
3.19
534D-9, 534D-10 & 544D
Boom
3.7.2
Extend/Retract Cylinder Installation
1. Install the extend/retract cylinder into the push beam
and line up the rod eye to the access holes (2). Be
certain that the wear pad is installed at the rod end
of the cylinder.
2. Install the rod eye mounting pin and secure.
3. Install the extend/retract cylinder base mounting pin
(3) into the strong back and secure.
4. Apply Loctite 545
®
to the extend/retract cylinder
fittings and install into the cylinder barrel.
5. Apply Loctite 545
®
to the fittings and reconnect the
hydraulic hoses.
MX0320
3
2
Advertising