5 mounting & connecting the electrical system, Dual air locker system – ARB RD105 User Manual
Page 39
Advertising
5 Mounting & Connecting the Electrical System
37
5.2.2.2
Dual Air Locker System
c If two Air Lockers are to be installed in the system, ARB
recommends that the switches and solenoids be wired according to
figure 27. For safety reasons, this configuration allows SOLENOID
2 to be actuated only if SOLENOID 1 is already on.
c Attach the “REAR AIR LOCKER” switch cover to SWITCH 1, and
the “FRONT AIR LOCKER” switch cover to SWITCH 2.
NOTE :
Refer to Figure 25. for the correct switch terminal
identification and switch orientation.
c Configure SOLENOID 1 as the air line leading to the rear axle Air
Locker, and SOLENOID 2 as the air line leading to the front axle Air
Locker.
Figure 27.
DUAL Air Locker SYSTEM
Advertising