6 testing & final assembly – ARB RD168 User Manual
Page 39
Advertising
6 Testing & Final Assembly
37
Figure 23.
F
Remove the long cross shaft.
Figure 24.
F
Rotate the differential until the ‘C’ clip access window is in full view.
F
Insert both axles fully into the housing and gently tap them inward
as far as they will go.
NOTE : To prevent damage to the oil seals, support the weight
of the axle shaft when inserting them.
F
Using needle nosed pliers, insert one of the ‘C’ clips onto the
groove in the axle shaft by sliding it between the spider block and a
side gear. (Refer to Figure 25.)
NOTE : You may have to slide the axle shaft outward very
slightly to adequately line up the groove.
Advertising