ARB RD119 - Manual (Page 15)

3 Installing the Air Locker
13
Figure 6. shows that approximately 1.5mm was ground from the
housing corner near the pinion support bearing to provide 2mm of
clearance for the Air Locker
Figure 6.
Once the required clearance has been achieved, remove the Air
Locker and the pinion shaft assembly and thoroughly clean the third
member of any grinding dust or other foreign particles.
Reinstall the pinion shaft assembly and using a torque wrench
tighten to the torque specified in your vehicle service manual.
Reinstall the Air Locker into the third member.
Install the bearing caps oriented as they were marked before they
were removed, and finger tighten the bearing cap bolts. It is not
necessary to torque them down at this time.
Insert and lightly hand tighten the appropriate adjuster nut supplied
with the Air Locker kit into the flange side bearing cap.
BEFORE
AFTER