ARB RD94 - Manual (Page 13)

4 Installing the Air Locker
11
4.1 Installing the Carrier Bearings
c With the Air Locker well supported in an arbor press, apply a thin
film of high-pressure grease to the ring gear side-bearing journal,
and assemble the newly established shim pack (thickness ‘D’ in
Fig.5.) onto the bearing journal.
c Press a tapered roller bearing cone onto the bearing journal of the
differential carrier until the bearing seats firmly against the shim
pack.
NOTE : Never re-use any bearings that are damaged or worn.
c Invert the Air Locker and apply a thin film of high-pressure grease
to the seal housing side bearing journal.
c Press an original bearing cone onto the Air Locker bearing journal,
taking care not to damage the O-ring grooves. (Figure 6.)
Figure 6.
NOTE : Do not add any shims between the seal housing
bearing and the bearing seat.