ARB 3782882 - Manual (Page 2)

25/10/2008 Page 2 of 5 3782882
TOOLS REQUIRED –
Basic Tool Kit
½” drill and ½” drill bit
PROCEDURE – Refer to winch fitment details overleaf before
proceeding
1. Remove the standard bumper and skirt.
2. Remove splash pan and strengthening plates where fitted.
3. FRONT LEAF SPRING MODELS ONLY
Remove the bolts that retain the front shackle pin retaining plates. Remove
shackle pin nuts and washer. With a soft hammer knock pins back flush with
chassis. Do not remove pins.
4. FOR 4 RUNNER VEHICLES ONLY
Refit 2 indicator plastic plugs to square holes in indicator brackets in bull bar.
Using 2 self-tapping screws from ARB kit and 2 original screws refit
indicators into bull bar. Use the 2 original screws where the plastic plugs were
fitted and the 2 new screws from the back of the bar through the bracket and
into the light.
When the bull bar is fitted reconnect to original plugs.
5. ALL MODELS
Lift bull bar into position. Fit four 12mm bolts (with 17mm head) and spring
washers supplied and four 14mm bolts, spring and flat washers supplied
through bull bar holes into chassis.
6. Fit two 12mm x 40mm bolts & spring washers behind air deflectors into front
chassis cross member. Do not fully tighten yet.
7. Fit 4 original bumper bar mounting bolts through bull bar wing brackets into
side bumper bar chassis mounts.
Part Nos:
3414020
3414030
3414060
3414070
8. Fit two 12mm x 35mm bolts, flat & spring washers supplied with offset 38mm
washer to rear of bull bar to chassis with offset washer clamping bar to
chassis.