ARB 3782882 - Manual (Page 4)

25/10/2008 Page 4 of 5 3782882
If the control box is to be mounted under the bonnet see Note 1 below.
Part Nos:
3414020
3414030
3414060
3414070
7. Position the winch on top of a 20 litre or 60 litre drum with the mounting holes
facing upwards.
8. Note: Only for Part No 3414020
Place 8mm packers over the winch mounting holes.
9. Place the bull bar on top of the winch and align mounting holes. Using bolts
supplied with winch and 3/8” washers in ARB kit, fit and finger tighten the
two upper bolts.
10. Place roller fairlead in position over two lower holes and fit two 1 ¾” x 3/8”
bolts and 3/8” washers supplied in ARB kit and finger tighten.
11. Ensure winch and roller fairlead are aligned and tighten all bolts.
12. Using 6” bolts supplied, place a flat washer under the head of both bolts and
insert bolts through roller fairlead bracket and side rollers. Fit nylon nuts and
tighten so that rollers turn freely.
13. Fit bull bar to vehicle following procedure on page 1.
14. Wire up winch as per winch instructions.
15. If driving lights are fitted, wire up.
16. Check operation of winch as per winch manual.